Hosco P-105W-RH Stratocaster USA Backplate, white

Premium product from Japan.

Cover for Fender USA Stratocaster, Circular holes. Milled from a special 1-layer material.

The surface may appear matte or even scratched - no worries, everything is fine. The surface is protected from the factory by a transparent transport foil that you may not even notice. It is temporary protection, remove it carefully after installing the cover.

The cover thickness is 2mm. The screw hole diameter is 3.5mm.

Screws are not included. You need 6 screws. Oval head screws are commonly used, which are partially recessed, and the head still protrudes slightly above the surface. A good choice is 3mmx11.5mm screws.

If you are looking for old Vintage screws, or oval heads with an old-fashioned groove for a flat screwdriver, check out 3mmx12mm screws.

If you want a smooth surface without a protruding head, you need recessed flat-headed screws 3mmx12mm.

If you are choosing a cover for an existing guitar, pay attention to the dimensions! Especially note the spacing of the six mounting screws on your guitar and compare them with our image. The displayed cover matches the screw position of the Fender USA Stratocaster.

If you are looking for a back cover for a Stratocaster with slightly different dimensions than Fender USA, you will also find it in this category.