Hosco P-105M Stratocaster Backplate, mint 3-layers

Premium product from Japan.

Guitar cover, Oval holes. Milled from a special 3-layer material.

The surface may appear matte or even scratched - no worries, everything is fine. The surface is protected from the factory by a transparent transport foil that you may not even notice. It is temporary protection, remove it carefully after installing the cover.

The cover thickness is 2.7mm. The screw hole diameter is 3.2mm.

Screws are not included. You need 6 screws. Oval head screws are commonly used, which are partially recessed, and the head still protrudes slightly above the surface. A good choice is 3mmx11.5mm screws.

If you are looking for old Vintage screws, or oval heads with an old-fashioned groove for a flat screwdriver, check out 3mmx12mm screws.

If you want a smooth surface without a protruding head, you need recessed flat-headed screws 3mmx12mm.

If you are choosing a cover for an existing guitar, pay attention to the dimensions! Especially note the spacing of the six mounting screws on your guitar and compare them with our image. The displayed cover differs in screw position from the Fender USA Stratocaster by about 2mm.

If you are looking for a back cover for a Stratocaster with the original dimensions of Fender USA, you will also find it in this category.